Force calculations
Wire length L
If the geometry of the sample and the wire length are known the resultant angles and forces on the bonds during wire pull can be determined. If the wire length L is unknown, it can be calculated from the loop height.
![Wire-pull-calculate-length](https://www.xyztec.com/wp-content/uploads/2023/06/Wire-pull-calculate-length.png)
The general equation is as follows:
If there is no height difference between the first and second bond and the pulltest is performed mid span, the equation can be simplified to:
Position d1 from first bond angle θ
If you want to pull with a specific angle θ at the first bond, calculate the test position along the wire according to the following formula.
Position d1 from second bond angle θ
![Wire-pull-distance-from-second-bond](https://www.xyztec.com/wp-content/uploads/2023/06/Wire-pull-distance-from-second-bond.png)
You can use the same equation to calculate d1 for the second bond by making h2 negative. Φ then becomes θ and d1 is measured from the second bond.
Angle at second bond Φ
The angle at the second bond Φ is derived from this expression.
Pull at equal angles
If you want to pull with equal angles (θ=Φ), the following formulas apply.
![Wire-pull-force-schematic](https://www.xyztec.com/wp-content/uploads/2023/06/Wire-pull-force-schematic.png)
The forces t, p and s then are as follows.